I got off work early but was still in work mode, so I went outside and installed these new markers that arrived in the mail today. Even when colored, they appear far superior to the factory version. Small details. I recommend them to all K5 owners.
4 Likes
Is it hard to install for someone who know nothing about car ?
4 Likes
Same question here! 
3 Likes
No, it’s not hard. Here are the steps.
-Remove the push pins from the wheel well. -Remove the screw that holds the bumper to the fender. -Remove the 10mm screw closest to the outside bottom of the bumper. -From the inside of the wheel well, pop out the top corner of the bumper, which snaps in and out, leaving enough room for your arm and tools. -swap lights, hand twists on the screw, I pushed the screw in, causing the light to move out of its appropriate seating position, got my electric side ratchet in there, zip the screw down, plug in harness, test, repeat.
I hope this helps, it’s extremely simple!
2 Likes
Those look swweeeettt
1 Like
you think they will fit the 2025